Using AS/400 data - issue is multiple selects in the command

I have to make a graph report that is based on a screen report on the server.

this involves showing the status of work in the company at given points in the manufacturing process, i.e. picking, engraving, etc.

would like to load them into the CR as one unit. But the CR rejects more than one. But is this a CR issue or is there syntax needed to run more than 1 CR. Is the issue in the crystal syntax ?

SELECT count(*)as Picking FROM                         

                       
CCDTA.OEORH48,CCDTA.TRNSTAT2,CCDTA.OETRA99                  
WHERE OHCOM# = TSCOM# AND OHORD# = TSORD#                            
AND (otCOM# = OHCOM# AND OTORD#= OHORD# AND ottrnc = 'AQC')          
AND OHORDT IN('RTR','INT','SAM') AND TSSTAT IN('ECT','STP')          
AND OHREQD = replace(char(current date, iso), '-', '')  AND          
OHHLDC = ' 'AND OHORD# in(SELECT a.TSORD# FROM ASTCCDTA.TRNSTAT2 a   
WHERE a.tsstat IN('AEP','BGE','EAS','REL','STP'));

SELECT count(*) as LaserENG FROM
CCDTA.OEORH48,CCDTA.TRNSTAT2,CCDTA.OETRA99                    
WHERE OHCOM# = TSCOM# AND OHORD# = TSORD#                             
AND (otCOM# = OHCOM# AND OTORD#= OHORD# AND ottrnc = 'AQC')            
AND TSSTAT IN('EAS','REL','SCC')                                       
AND OHORDT IN('RTR','INT','SAM')                                       
AND OHREQD = replace(char(current date, iso), '-', '')  AND OHHLDC =   
' '